How to change the rule values the checks use, and who signs them off
This video is coming soon
The written steps below already work. Come back to watch it.
How to change the rule values the checks use, and who signs them off. Only Owner / Administrator and Engineer / Document Control see Engineering → Design rules (Design rules).
The steps, written out
- Type a new Value for any rule (max. gap between platform and wall, min. platform width, max. vertical and horizontal tie spacing, max. height-to-base ratio, max. base jack extension, top and mid guardrail heights). Lengths are in metres; leave a value blank to use the engine default.
- Fill Source / standard, Signed off by and Sign-off date (the last two are required).
- Press Save rule values.
Tip
The In effect column shows what the checks now use, and the values are printed on the drawings.